Lift the washer onto the ramp and shift it up towards the middle of the beam. Continue sliding the washing machine over the other side of the ramp, down to the pan. Once the back edge of the washing machine is in the pan, slide the 2×4 ramps out from underneath, gently lowering the rest of the washer into place.
How can I lift my washing machine by myself?
Move the hand holding the leg stand at the front to the corner at the back, so you’re holding both sides. Lift the washing machine and let it rest on your leg. Pull the appliance up to your chest and keep your arms at a 45-degree angle.
Should I put a drain pan under my washer?
Drain pans aren’t a requirement for your washer, but they are an inexpensive and simple way of protecting your home by catching small leaks and reducing the amount of water damage from broken hoses. If your laundry room is upstairs, a drain pan is recommended to protect against leaks that can seep into the rooms below.
Can you drain a washer upwards?
In order for the drain hose on your Front Load washer to function properly, the drain must be at least 24″ up from the floor and less than 8 feet high. GE and Hotpoint Top Load, Front Load and Unitized washers have powerful drain pumps that can pump water vertically as high as 8 feet above the floor.
Can you move a washing machine in a car?
The likelihood is that your washing machine will not fit comfortably in your car. Especially if it is still secured upright, which it always should be. During the drive, you (or your courier) should try to avoid bumps in the road as much as possible, as this could damage the washing machine’s delicate engineering.
How do you move a front load washer without shipping bolts?
If you cannot use shipping bolts, you’ll want to make sure there’s no water in the bottom of the tub, and fill it with furniture blankets. Remove the drain hoses and power cord, wrap the machine with dolly straps, and load it onto a hand truck or dolly for transport.
What are the 3 drawer for in a washing machine?
All the 3 compartments are separate. These are the main wash, prewash, and fabric softener.
How do you drill a hole in a washer pan?
Use a screwdriver to knock out the perforated knockout on the bottom or side of the drain pan. If the model does not have a precut hole, use a power drill with a 1-inch hole saw to drill a hole according to the pan’s instructions.
Can you drain a washer into a floor drain?
Can I Connect My Laundry Tub Drain To The Floor Drain? A laundry tub should only drain to a floor drain when the floor drain connects directly to the main sewer system pipe. You should never have your laundry tub drain into a floor drain that connects to a sump pit.
How much does it cost to install a drain pan?
What is the cost of replacing a drain pan? Depending on the type of A/C you own, the cost for a replacement can run anywhere from $50.00 to as much as $10,000.00. If you have a professional do the work, you may be looking at substantial labor fees as well.
Do laundry rooms require a floor drain?
The 2017 IRC code does not specifically require floor drains to be installed in laundry rooms, but buildings often include them to provide for emergency drainage or to help with other drainage needs (e.g., relief valves, water heater drainage, condensate drainage, etc.).
How far can I extend my washing machine drain hose?
Washing machine manuals typically specify a minimum height of 39” for the entry of the drain hose into the standpipe or faucet box, and a maximum height of 96” (8 feet).
Can a washer drain hose be too long?
What if the drain hose for the washing machine is too short? Having a drain hose that’s too long is one thing, but you can also end up with one that’s too short. If you can’t get the hose to reach the necessary height and into the standpipe, you need a longer hose. Alternatively, you can use an extension kit.
What happens if you lay a washer on its side?
If you lay your washer on its side, you risk bumping the inner and outer tubs against one another, which can lead to unwanted issues like loose pads, a damaged suspension or knocking your washer out of alignment.
How do you move a washing machine without damaging the floor?
Place something down to protect the flooring or put something under the feet. Tip: Avoid damage to the flooring by placing an old towel (or towels) under the feet. This also helps the machine slide around easier.
Can you transport a washer and dryer on its back?
It does not harm the dryer to lay it on its side or back during transporting. Exception: Unitized washer/dryer models should only be transported / moved in an upright position. Do not lay on side or back.
What happens if you move a washing machine without transit bolts?
Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. However, you must remember to remove the transit bolts once your move is complete, as they can seriously damage your machine should you begin a wash cycle with them still in place.
How do you move a front load washer?
How to Transport a Front Load Washer Slide your front-load washer away from the wall far enough to access the power cord. Place a bucket on the floor behind your washer. Move your washer from the laundry room. Find the shipping bolts that were removed when your washer was first delivered.
Where do you put vinegar in a washing machine?
For softening your clothes, add the vinegar to your fabric softener dispenser. To fight mild odors, add it directly to the washing machine basin during the rinse cycle, or use it in place of regular detergent and add it again during the rinse cycle if you need to remove really strong odors.
What happens if you put detergent in the wrong compartment?
If you put soap in the soap dispenser and soap in the fabric softener dispenser then all you have done is wash your clothes twice and need to add an extra rinse cycle or two. Nothing bad happens to your hair when you reverse the process and nothing bad happens to your clothes either.
Does liquid detergent go in the drawer?
Liquid detergent can be used in any of our detergent dispenser drawers. On a few machines (including the Auto Dose and Soft Water machines) the liquid is retained in the drawer by a liquid “insert” or “boat”. This is a separate item and fits into the space where the powder usually goes.