Never lay insulation over recessed light fixtures or soffit vents. Keep all insulation at least 3 inches away from “can” lights, unless they are rated IC (Insulated Ceiling). If you are using loose fill insulation, use sheet metal to create barriers around the openings.
How do you keep insulation from blocking soffit vents?
Seal all cracks, seams and holes using caulk or spray foam sealants. Use solid blocking for any larger holes or open soffits. Metal blocking and collars can be constructed around hot flues to keep insulation from touching them.
How do you keep blown insulation from falling down?
Unfortunately, blow-in insulation can drift into the vents and block the flow of air. The solution is to install rectangular attic baffles, formed to fit between the rafters. Cardboard or thin plastic baffles allow the air to flow into the attic, yet serve as a dam to hold blow-in insulation in the attic.
Do I need baffles in every rafter?
Attic venting baffles channel the air from outside, continuing the circulation. This is what keeps your home cooler. So, while rafter air channels are not required between every rafter, they are necessary for each air intake piece.
Should soffit vents be covered with insulation?
In the summer, natural air flow in a well-vented attic moves super-heated air out of the attic, protecting roof shingles and removing moisture. The insulation will resist heat transfer into the house. NEVER COVER ATTIC SOFFIT VENTS WITH INSULATION — use rafter vents and soffit vents to maintain airflow.
How do you tell if attic is properly vented?
How to determine whether you need better attic ventilation Look at your eaves and roof. Touch your ceiling on a warm, sunny day. Thick ridges of ice on your eaves in winter are a sign of poor attic ventilation. Warm air that escapes living space also carries moisture that will condense on rafters or roof sheathing.
Can you cover attic insulation with plywood?
Once the insulation is down, you can turn your attic into valuable storage space by covering the floor with plywood. It will also make the attic a safer place in which to walk.
How do I know if my soffit vents are blocked?
There are two easy ways to check this. If you can get into the attic when it’s dark (or bring a flashlight but then turn off the attic lights), see if you see light when looking into the eaves – if so there were openings cut. If not there were either no openings or they are blocked.
Is blown in insulation better than rolls?
The environmentalists in your family will likely favor it over the rolled kind of fiberglass insulation. Blown fiberglass insulation scores an R-value of 3.2 to 3.8, making it slightly less likely than rolled fiberglass to prevent the flow of heat into and out of your house.
What happens if attic is not vented?
Insufficient ventilation can lead to moisture problems during the winter and decreased energy efficiency during the summer but too much ventilation can be just as bad, if not worse. Roof vents create an additional roof penetration, essentially another place of vulnerability where leaks can occur.
How can I insulate my attic without soffit vents?
What do you do if your attic doesn’t have soffit vents and you are unable to add them? Install low gable vents located above the top level of the attic ceiling insulation. Use “eye-brow” vents that are on the top of the sloping roof surface near the soffit/eave area. Focus on the other ventilation you have in the attic.
How can I vent my attic without soffits?
To ventilate your attic without soffits you can use gable vents, eyebrow vents, a venting drip edge, a shingle-over intake vent, wind turbines, or power vents. All are good alternatives if you cannot install soffit vents; however, a very important factor for good ventilation is good insulation.
Can an attic have too much ventilation?
It’s possible to have too much exhaust ventilation, but you cannot have too much intake ventilation. If there is more intake ventilation than the attic’s square footage requires, it’s not problematic because any excess intake converts to “exhaust” on the leeward side of the house.
Do I need baffles if I don’t have soffit vents?
But not all homes have an overhanging roof line or soffit vents. Without them it is actually easier to insulate your attic, because you do not have to worry about covering up the vents or installing rafter baffles to ensure the vents breathe.
Are cardboard attic baffles good?
The foam baffles hold up in Michigan’s humidity, whereas cardboard baffles can absorb moisture causing them to fall and be ineffective. In addition to offering airflow in your attic space, baffles keep attic insulation off your roof deck, which is especially important for cold Michigan winters.
How many vents should you have in your soffit?
Ideally, half the vents should be located in the soffit at the bottom of the roof and half in gable or ridge vents near the top to allow for natural circulation of air through the attic. Example: a 50′ x 30′ attic would have a total area of 1,500 sq. ft., divided by 150 equals 10 sq. ft.
Will soffit vents stop condensation?
There are various eaves vents that can be installed to help reduce condensation in the eaves section of the roof. Soffit vents and fascia strips can both be installed to both new and existing roof-line boards. These can be used in conjunction with other types of ventilation or as a stand alone product.
Do I need to vent my soffits?
So, does my roof need soffit vents? A roof may need soffit vents if there is no other ventilation allowing for adequate air movement. However, if the attic space is properly sealed and insulated, there is no need for this type of ventilation. Soffit vents are an easy, aesthetically pleasing way to vent the attic space.